Mold Testing


    Home / Services / Mold Testing

Our in house plastic injection presses allow Calframax to test all molds extensively for customer satisfaction as well as research and development options.

Testing Room Specifications:

  • Chiller unit
  • Compression testing
  • Resin recycling system
  • Drop testing
  • 10 Ton lifting capabilities
  • 500 Ton press options
  • 1000 Ton press options

Press Specifications 500 Ton:

Husky Hylectric 500

  • Max screw speed: 270 RPM
  • Max Injection Pressure: 29,349 PSI
  • Tie Bar Spacing: 40.16 in X 40.16 in
  • Max Mold Height: 40.25 in
  • Minimum/Maximum Press Opening: 13.78 to 50 in

Press Specifications 1000 Ton:

Husky Hylectric 1000

  • Max screw speed: 145 RPM
  • Max Injection Pressure: 31,900 PSI
  • Tie Bar Spacing: 61.02 in X 51.97 in
  • Max Mold Height: 83.22 in
  • Minimum/ Maximum Press Opening: 31.50 to 97.64 in

Added Value

Calframax has the capability to complete a full or partial rebuild on our customers’ mold’s. This rebuild will allow customers’ mold’s to run like new even after millions of shots and years of cycles

Additional Resources:

  • Sand Blasting
  • Laser Welding and Cladding
  • Texture Repair
  • Chroming and Nickel Plating
  • Laser Engraving
  • Heat Treat and Various Material Treatments
  • Onsite Inventory/Trucking
  • Laser Welding
  • Laser Engraving
  • Onsite inventory allows for spare parts and components to be shipped to our customers without any delay
  • Our own trucking allows all manufactured parts to be in the control of Calframax at all times.